An ECOA Lift Table that could withstand seismic variations

seismic 

 ECOA Lift produced a lift table that could withstand seismic variations. This customer needed a lift table that could withstand seismic variations (earth quakes) and remain stable and safe. The material that is on the lift is very toxic and dangerous. The operation required the material to be loaded on a carrier and the carrier was rolled on to the lift and raised to a height that allowed to material to be moved off the lift to its final destination.

The red cylinders control the added legs used for stability in case of ground vibrations. The lift is raised and the legs are then moved to a vertical position and aligned with cup receivers and lowered it to those receivers for security.
The operating system can not operate unless all moving parts are in there correct position and only then will the lift operate. If at any time any of the movable components become out of position the lift will immediately stop until the situation is corrected.

Because of the proximity to a very hot area the paint and components had to be of special material to resist the heat.

Comments are closed.